GSM remote control FLAJZAR GSM-DIN3 for DIN rail

Product detailed description

GSM remote control FLAJZAR GSM-DIN3 for DIN rail
Modern GSM control of the new generation!

Universal GSM device, transmitting information using the GSM network. Allows easy control of appliances and status monitoring using your mobile phone. The communicator contains two power outputs with contact loads up to 230V/5A. It is then possible to change their status remotely by SMS or by simply calling them (free of charge), or to use the timer and thermostat function with the connection of an external temperature sensor.

The GSM-DIN3 is equipped with two universal inputs to which any sensor contact can be connected. You will then receive an informative SMS message or call on your mobile phone when these inputs are activated. The inputs can be switched to activation/deactivation input mode for connecting keypad, RFID, remote control receiver. The device then serves as a small alarm control panel with the possibility of activation/deactivation by the access control system. Each input can be named separately (text of the SMS sent). In case it is necessary to have the inputs permanently active (in guarded state), it is possible to switch them to 24h loop mode.

Internal Li-ion battery ensures the communicator operation even in case of 230V mains voltage failure
Possibility of 230V mains voltage monitoring - SMS are sent when the mains voltage is lost and restored
Easy configuration with PC software and included USB cable
The device is designed for dry environments. For outdoor installation, use an enclosure with adequate protection
Two universal inputs with adjustable response to change, disconnect or loop connection
Departure and arrival times can be set from 10 to 90 seconds
Input for digital temperature sensor with the possibility of automatic control of both relays (thermostat)
Information SMS in case of exceeding the set temperature or temperature drop below the set limit
Two output relays 230V/5A (resistive load), each relay can be assigned a timer up to 10 hours, you can select control commands for each (e.g. "Turn on heating", "Turn off heating" ...)
You can check the status of the device at any time by SMS status message
The GSM-DIN3 can be configured quickly and easily using a clear and intuitive PC program. The program makes it easy to make all settings, save and load them to/from the configuration file
During installation you will also appreciate the online GSM signal strength detection function

Technical parameters:

Dimensions (h x w x d): 90 x 36 x 58mm
GSM/GPRS Quad Band 850/900/1800/1900 MHz
Supply voltage: 230V AC
The communicator is backed up by an internal 3.7V/550mAh LI-ion battery
Current consumption - networked, quiescent state: approx. 10mA
Both relays open: 100mA, when charging the battery: 300mA
Max. current consumption (GSM module transmits): peak approx. 330mA
Operating temperature: -20 °C to +50 °C
2 logic inputs, separated by optocouplers, active GND level
The inputs are designed for connecting potential-free contacts!
1 input for digital temperature sensor with measuring range from -20°C to 125°C
2 power relays 230V AC, contact current up to 5A (resistive load)