Parking sensors MNC 54992A

Product detailed description

An extremely innovative product that requires no assembly work, discreet, unobtrusive yet works excellently. You don't need to drill a bumper to install it, as with conventional ultrasonic reversing radars. The technology is based on the electromagnetic principle: The electromagnetic field is the area of action created by electric and magnetic fields, filling the space that is generated by an open circle of vibrations behind the car, similar to a retractable radio antenna. If any object enters this field the internal unit will start beeping signalling an approaching object. The reversing tape has a thick self adhesive layer which is not heat soluble, the tape needs to be attached to the inside of the bumper and connected to the internal control unit. The power supply is handled from the reversing lamp bulb, so the sensor is only activated while reversing. If you are unsure about the installation, please consult a professional.

- Innovative, electromagnetic principle
- No need to drill out the bumper
- There is no dead angle due to belt continuity
- Easy installation
- Compatible with any car
- Cuttable to the required length
- It can be installed on the front and side of the vehicle as required
- Loud indication of an approaching object (beep, dense beep, continuous beep)


Installation:
If you need better access, remove the bumper!
Clean and degrease the inside of the bumper
Attach the tape to the bumper without gluing, then cut to size. You can also tape over the side wall of the bumper to avoid dead angles.
Stick the tape on a flat surface, make sure it is not wrinkled, flatten it. If your car has a tow hook the tape needs to be placed higher so that the hook does not fit into the angle of the belt.
ATTENTION! You can remove the tape after sticking it, but it cannot be re-sticked.
Connect the control unit to the tape connector and place it in a location where it cannot be hit by water. Secure power to the device from the reversing bulb. Make sure the connectors are properly insulated!
Place the loudspeaker in the desired position (under the rear seat, in the luggage compartment), attach the accessories using double-sided adhesive tape.
Insert the return line and ask someone to help you during testing.

Technical parameters:

- Power supply: 12 V
- Belt length: 220 cm
- Detection distance: approx. 60 - 70 cm
- Detection Technology:Electromagnetic