Recuperation VENTIKA Solo+ 100mm

Product detailed description

Local recuperation unit Ventika

Suitable for residential houses under renovation as a replacement for negative pressure ventilation using fans or new construction where permanent ventilation is required without heat leaks.

- ease of assembly
- easy operation
- easy maintenance
- quiet operation
- economical EC motor

The unit operates in two 60 second cycles:

I cycle
The warm air exhausted from the room flows through the heat exchanger and transfers the heat.
After 60 seconds of heating the heat exchanger, the ventilation unit switches to supply mode.

II cycle
Fresh, cool outside air flows through the heat exchanger.
The air is heated by the heat that was previously stored in the heat exchanger.
After 60 seconds, the fan switches back to extraction mode and the cycle repeats.

Control
The unit is operated by remote control. When On/Off is turned on on the remote control, the fan will run at the speed at which it was turned off.
You have a choice of 2 fan speeds. The speed at which the fan operates is indicated by a coloured LED on the front panel of the indoor unit. The first (lower) speed corresponds to the green colour, the second (higher) speed corresponds to the blue colour LED.
A change in remote control commands is confirmed by a momentary decrease in LED brightness.
The operation of the unit can be controlled by a humidity sensor. Use the included plastic screwdriver to set the desired humidity level between 60-90% on the potentiometer. If the humidity in the room exceeds the set value, the unit will automatically switch to the second (higher) speed and operate until the humidity returns to normal. Once the humidity is vented, the unit returns to the previous operating mode.
In case of high humidity in the outside air, the heat recovery unit may switch to the second (higher) speed due to the humidity sensor trigger. If such switching is undesirable, turn off the humidity sensor temporarily.
Night mode switches the fan to the first (quieter) speed and dims the backlight for 8 hours. The unit does not respond to speed switching and humidity sensor triggering in this mode. After this time has elapsed, the fan will return to the previous operating mode. The night mode can be switched off at any time using the remote control.