Photovoltaic solar panel 12V/50W SZ-50-MC 865x365x2mm monocrystalline flexible

Product detailed description

Solarfam photovoltaic panel is made of monocrystalline silicon. It is lightweight and semi-flexible and is primarily designed for mounting on slightly curved surfaces, e.g. on boats or caravans. It is equipped with 90 cm long cables with MC4 clamps. It is designed for 12 V system voltage and, with respect to the Vmp parameter, for MPPT controllers.
Fully waterproof panel construction.

CPC
The CPC material used on the surface has good weather resistance and high light transmittance, and its performance is better than that of ETFE material. The integration of composite material has better protection for solar cells compared with traditional flexible panels. The panels are very lightweight, easy to carry and install.

Technical parameters:

Maximum no-load voltage Voc = 22.44 V
Max. short-circuit current Isc=2,77A
Max. voltage at 50 W output: Vmp=19.14 V
Max. current at 50W: Imp=2.62A
Operating temperature: -40°C to +80°C
Number of articles: 33
Max. system voltage: 200V
Cable length: 90cm/2.5mm2
Clamps: MC4
Dimensions: 865x365x2mm
Weight: 1.3 kg
Protection: IP67
CE, RoHS

Single crystal cell description
In order to produce a single crystal cell, it is necessary to produce a uniform ingot of quartz crystal.Such production is relatively difficult. The round ingot is cut into so-called wafers, which are cut to the desired size of the photovoltaic cell. Since the ingot is formed as one large silicon crystal, its structure is uniform and very pure.

Benefits of single crystal
Higher cell efficiency and therefore higher power output from the same area
Slightly slower "aging" of silicon, i.e. panel performance degrades more slowly with time
the colouring of the cells is homogeneous, the panels are not "mottled"

Installation
When bonding a flexible panel to the roof of a vehicle, caravan, etc., it is necessary to take into account the different expansions of the roof and the panel material, which can cause damage to the flexible panel.
It is recommended to glue the flexible panels on an intermediate layer of "Makrolon Plaxiglas", which also allows air flow under the solar panel, thus increasing its efficiency. Please note: the flexible panel can only be bent with the longer side at a maximum angle of 20°.