Photovoltaic solar panel 12V/80W SZ-80-MC 760x600x2mm monocrystalline flexible

Product detailed description

Solarfam photovoltaic panel is made of monocrystalline silicon. It is lightweight and semi-flexible and is primarily designed for mounting on slightly curved surfaces, e.g. on boats or caravans. It is equipped with 90 cm long cables with MC4 clamps. It is designed for 12 V system voltage and, with respect to the Vmp parameter, for MPPT controllers.
Fully waterproof panel construction.

CPC
The CPC material used on the surface has good weather resistance and high light transmittance, and its performance is better than that of ETFE material. The integration of composite material has better protection for solar cells compared with traditional flexible panels. The panels are very lightweight, easy to carry and install.

Technical parameters:

Maximum no-load voltage Voc = 22.44 V
Max. short-circuit current Isc=4,43A
Maximum output voltage 80 W: Vmp=19.14 V
Max. current at 80W: Imp=4.18A
Operating temperature: -40°C to +80°C
Number of articles: 33
Max. system voltage: 200V
Cable length: 90cm/2.5mm2
MC4
Dimensions: 760x600x2mm
Weight: 1.81 kg
Protection: IP67
CE, RoHS

Single crystal cell description
In order to produce a single crystal cell, it is necessary to produce a uniform quartz crystal ingot. Such production is quite difficult. The round ingot is cut into so-called slices, which are trimmed to the desired size of the photovoltaic cell. Since the ingot is formed as one large silicon crystal, its structure is uniform and very pure.

Benefits of single crystal
Higher cell efficiency and therefore higher power output from the same area
Slightly slower "aging" of silicon, i.e. panel performance degrades more slowly with time
the colouring of the cells is homogeneous, the panels are not "mottled"

Installation
When bonding a flexible panel to the roof of a vehicle, caravan, etc., it is necessary to take into account the different expansions of the roof and the panel material, which can cause damage to the flexible panel.
We recommend gluing the flexible panels to the intermediate layer "Makrolon Plaxiglas", which also allows air flow under the solar panel, increasing its efficiency.Note: the flexible panel can only be bent on the long side and at an angle of no more than 20°.