Tinycontrol current sensor up to 30A for LAN driver LK3 and LK4

Product detailed description

Non-invasive current transformer SCT-013-030 for current measurement by indirect method. The output AC voltage is proportional to the current in the main conductor and is designed for the LAN driver LK3 and LK4. Measurements must be made on only one conductor and not on the entire cable where current flows in both directions. The sensor connects to the INPA1-4 and GND inputs for these inputs. It comes with a 3.5mm jack connector (male) that can be cut to the desired length or a 3.5mm jack connector (female) can be connected to the LAN driver with the wiring shown in the photos. Technical parameters: AC current range: 0-30 A (AC) Maximum diameter of conductor to be measured: 12 mm Built-in sampling resistance: 62 Ohm AC output voltage: 0-1 V (AC) Cable length: 1 m Weight: 45 g Operating temperature (°C): -25 to 70 Dimensions: 57 × 32 × 21 mm