Silicone for sealing engine parts during assembly K2 SILICONE BLACK 300g

Product detailed description

High quality silicone safe for lambda sensors and on-board computers. Meets the requirements of automotive manufacturers (O.E.M. - Original Equipment Manufacturer). Replaces traditional cork, paper, felt, asbestos and rubber gaskets. Thanks to the SENSOR SAFE formula, it does not damage lambda sensors in modern cars with electronic fuel injection.

Resistant to oils, lubricants, coolants, etc. Applicable to all types and makes of cars for sealing thermostat compartment lids, oil pans, water pump lids, cooling connection end caps, etc. Resistant to temperatures up to 350°C.

Instructions for use:

1. The surface must be dry, cleaned of dust, dirt and grease.
2. Remove the old, loose gasket.
3. Apply a small amount of silicone (any excess can be removed with a knife dipped in soapy water).
4. The silicone starts to dry after 5 minutes and is touch resistant after 1 hour, complete drying occurs after 24 hours.
5. Excess dried silicone can be removed with a razor blade.

Note: After each use, the tube must be properly closed.