Time switch 0-999sec, 0-999min, 0-999hr with two times

Product detailed description

Time switch with three adjustable time intervals and two time channels. The two times can be combined with each other in different ways. Time range 0-999sec, 0-999min, 0-999hr, setting valid for both channels simultaneously.


Technical parameters:

- power supply: 12 V
- 6 operating modes-see below
- relay contact 230VAC/10A or 12VDC/20A
- dimensions: 48 × 29 mm
- power consumption in quiescent mode: 20 mA
- power consumption when relay is closed: 120 mA
- panel opening: 45.5 × 26 mm

Operating modes:
- P1-0: the relay is permanently switched on after the T1 time has elapsed
- P1-1: relay is on during T1, then switches off permanently
- P1-2: the relay is switched on for T2 time after T1 time has elapsed, then the module is idle
- P1-3: relay is on during T1, then off during T2 and then on permanently
- P1-4: the relay cycles the T2 time after the T1 time has elapsed - it is switched off at the beginning of the cycle
- P1-5: the relay cycles for time T1 after time T2 has elapsed - it is on at the beginning of the cycle

Setting times:
- P0-0 - set to seconds mode
- P0-1 - setting to minutes mode
- P0-2 -setting to clock mode

Settings:
- press the SET button briefly to activate the time setting mode:
- T1 - the red display flashes and the arrow keys can be used to set the T1 time
- T2 - the green display flashes and the arrow keys can be used to set the time T1
- saving of set values is possible by short pressing SET again or automatically after 6sec of inactivity
- by long pressing the SET button it is possible to set the time units and operating modes:
-P0 - setting sec(0) - min(1) - throw(2) using arrows. The setting is valid for both channels at the same time
-P1 - setting the operating modes 0-5, see above, also using the arrows.
- saving of set values is possible by short pressing SET again or automatically after 6sec of inactivity

The module does not have a separate Start button. Timing starts by connecting the input voltage

The product is not a separately functional unit, it requires professional assembly.