DC-DC charger Orion-Tr Smart 12/12-30A (360W) isolated

Product detailed description

The Victron Energy Orion-Tr Smart DC-DC Charger is a professional DC-DC adaptive three-stage charger with built-in Bluetooth functionality. It is designed for use in dual battery systems in vehicles or boats where a (smart) alternator and starter batteries are used to charge the service battery. The unit can be monitored and programmed via Bluetooth and controlled remotely using a remote on/off switch. The charger is also equipped with an engine run detection mechanism.

Orion Tr-Smart chargers are available in 12V or 24V and are suitable for both lead acid and lithium batteries. Models up to 400 W are available. In addition, an unlimited number of units can be wired in parallel to increase output power.

It is suitable for use at high ambient temperatures, up to 55 °C, and at full rated output up to 40 °C.

With Bluetooth Smart connectivity
Any smartphone, tablet or other device can be used to monitor, change settings and update the charger when new software features are available.

Fully programmable
Battery charging algorithm (configurable) or constant output.
Compatibility with smart alternator: motor run detection mechanism.
Adaptive three-stage charging algorithm: fast - absorptive - floating
For lead acid batteries, it is important that the absorption time is short during moderate discharges to avoid overcharging the battery. After a deep discharge, the absorption time increases automatically to ensure the battery is fully charged.
The absorption time for lithium batteries is constant, 2 hours by default.
Or a constant output voltage can be selected.
Remote on/off
A remote on/off switch or relay contact can be connected to the two-pole connector, or the H (right) terminal of the two-pole connector can be switched to the plus battery terminal, or the L
(left) of the two-pole connector can be switched to the minus pole of the battery (or for example to the vehicle's carcass).

All models are equipped with short circuit protection and can be connected in parallel to increase output current
There is no limit to the number of units that can be connected in parallel.
High temperature protection
The output current will be reduced at high ambient temperature.
Protection IP43
When installed with the screw clamps facing downwards.

Screw clamps
Installation does not require special tools.
Input fuse (not interchangeable)