Solar LED wall light HS-8013 with PIR

Product detailed description

Practical LED wall light with PIR sensor, solar panel and Li-Ion 18650 3,7V/1200mAh cell. Ideal for placing in outdoor areas to be illuminated for safe passage.


Product parameters:

- continuous light mode without PIR sensor influence for 60min: can be set by remote control by pressing the ON (max power) or MODE3 (half power) button or repeatedly using the control button directly on the light body. In this mode, the luminaire will shine continuously for 60min without the influence of the PIR motion sensor and at the same time blocked by the ambient light. Li-ion battery consumption in this mode is 1.5A - full power or 0.42A - half power.
- light activation mode on movement - PIR sensor is active: it can be set by remote control to MODE1 or by repeatedly pressing the control button on the light bodies. In this mode, the luminaire will only make maximum power available when the PIR sensor is activated for 30 seconds, while this function will be blocked in ambient light. Li-ion battery draw in this mode is 1.5A when the light is on
- continuous light mode with maximum light activation by PIR sensor: can be set by remote control to MODE2 or by repeatedly pressing the control button directly on the light body. In this mode, the light will permanently illuminate with minimum power and the maximum illuminance will be activated by the PIR sensor for 30 seconds. The overall illumination is blocked by the ambient light. Li-ion battery draw is 0.04A permanently and 1.5A when activated by the PIR sensor.


Technical parameters:

- light source - LED COB, total 8× panel of 20 LEDs
- luminous flux: 500lm at maximum output
- PIR sensor: 120°, sensitivity 3m
- remote control: IR, 6 buttons
- power supply: 1× Li-ion 18650 cell
- charging: solar cell 65×95mm 5V/6W
- charging time: 8h in full sunlight
- the operation time depends on the operating mode. In continuous light at full power, the battery lasts about 2 hours, in occasional operation with PIR chip and several days without charging.
- dimensions: 270×145×30mm, holder length 140mm
- weight: 500g

Warning: used cells may be in an uncharged condition. Before first use, leave in direct sunlight for a few hours or disassemble (6 screws), challenge the cells and charge separately. When using good quality cells with 2500 mAH capacity, the operating time will be extended on average.