Solar PWM controller Victron Energy 5A LCD and USB 12V / 24V

Product detailed description

Solar PWM controller Victron Energy 5A LCD and USB 12V / 24V
New PWM solar controller from Victron Energy with full 5 year warranty!

Its design is intended for small island solar systems. To charge a 12V battery, the solar panel must have 36 cells, or to charge a 24V battery, the panel must have 72 cells and a maximum current of up to 5A.
With a 12V battery, a maximum panel power of up to 60Wp can be connected.
With a 24V battery, a maximum panel power of up to 120Wp can be connected (two 90Wp panels connected in series).
The advantage is very simple and easy installation and reliable operation.

Built-in clear LCD display
For status monitoring and parameter setting.

DC power supply for appliances
Excessive battery discharge can be prevented by connecting all DC loads to the DC output of the controller (terminal on the right).
The DC output disconnects the load when the battery is discharged to preset voltages. It reconnects the load automatically once the battery is at least partially recharged.
Connection and disconnection voltages are adjustable.
Do not connect a voltage converter to the DC output - connect it directly to the battery.


Programmable battery charging algorithm
Pre-programmed algorithms for AGM, GEL, liquid or LiFePO4 lead acid batteries (batteries with internal BMS only)

Two 5 volt USB outputs
You can easily use the USB output to charge your mobile phone, etc.
Maximum current (both outputs combined): 2A

easy installation
1. Connect the battery - plus and minus.
2. Connect the solar array - plus and minus.
3. Connect the load - plus and minus.
When uninstalling, the reverse order applies.
Failure to follow this sequence may damage the BlueSolar PWM charge controller!

1. Make sure the battery is charged before the first installation.
2. The cable to the battery should be as short as possible to minimize losses.
3. The controller is only suitable for lead acid and LiFePO4 batteries.
4. The charge controller is only suitable for regulating solar panels. never
do not connect another charging source to the solar controller.

Detailed technical information can be found in the enclosed datasheet and instructions.