Regulating fitting - corner, EC x 1/2"

Product detailed description

In central heating and plumbing applications, right-angle fittings are essential components for changing the direction of flow within a system. This type of fitting is commonly found in residential and commercial buildings, particularly in underfloor heating layouts or compact boiler rooms where space constraints require directional changes. The IVAR DS 306 model is designed for integration with copper or plastic pipe systems via compression fittings, ensuring secure and leak-free connections. Installers must consider the nominal pressure rating and material compatibility when selecting fittings for specific system requirements.

The design allows for straightforward installation without the need for soldering or threading, reducing potential errors and installation time. It is suitable for use with copper pipes connected using IVAR.TR fittings or plastic pipes with IVAR.TP fittings. Correct alignment during installation is critical to prevent stress on the joint, which could lead to leakage over time.

Technical parameters

Installation and connection

To install the fitting, begin by preparing the pipe ends according to the manufacturer’s specifications for compression fittings. Insert the prepared pipe into the fitting until it reaches the stop point, then apply the compression nut and ferrule. Tighten the nut with a wrench, ensuring even force is applied to avoid distorting the ferrule. Check the alignment of the fitting to ensure it does not impose torsional stress on the pipe. Common mistakes include overtightening, which can damage the ferrule, and misalignment, which can cause stress fractures in the pipe wall. Always verify the integrity of the connection after installation by inspecting visually and applying pressure gradually.

Compatibility and accessories

This fitting is specifically compatible with 1/2 inch copper or plastic piping systems connected through IVAR compression fittings. For copper pipe connections, use IVAR.TR fittings, while IVAR.TP fittings are required for plastic pipes. Additional components such as compression nuts and ferrules must be obtained separately. No alternative or related products are available for combination with this model.

Technical background for designers

The nickel-plated brass construction offers good thermal conductivity and long-term durability in wet and heated environments. Its integration into a system depends on proper sizing of the pipework and adherence to pressure ratings. Longevity is influenced by correct installation practices and the absence of chemical contaminants in the system fluid. Thermal expansion of the piping material must also be considered to avoid stressing the fitting joints.

Service and operation

During operation, no routine maintenance is required for the fitting itself. However, periodic visual inspections should be carried out to detect signs of leakage, corrosion, or mechanical stress at the joints. If any issues arise, the fitting must be removed and replaced by disconnecting the compression nut and replacing the ferrule. No scheduled service intervals are specified for this component.

Frequently asked questions

Can this fitting be used with copper and plastic pipe systems?
Yes, the fitting supports both copper and plastic pipe connections using IVAR.TR and IVAR.TP compression fittings respectively.

What is the maximum operating temperature for this fitting?
The maximum operating temperature is specified as +120°C according to the manufacturer's technical data sheet.

Is this fitting suitable for high-pressure heating systems?
The PN 10 rating means it is suitable for systems with a maximum operating pressure of 10 bar.

Does the nickel plating affect compatibility with other materials in the system?
No, the nickel plating provides a protective layer without interfering with the chemical compatibility of the system fluids or adjacent materials.