Victron Energy Sun Inverter 12V/250A-15 IEC

Product detailed description

The solar inverter combines a sine wave inverter and a PWM solar charger in one housing, is easy to install and requires minimal wiring. The inverter allows you to power home appliances requiring 230 VAC using ordinary household or car 12 V batteries. The solar charger will ensure that the batteries are charged with the energy obtained from your solar panels. The charging algorithm is programmable. The parameters of the inverter and solar charger can be displayed via Bluetooth using the VictronConnect app. In addition, the inverter can be connected via the VE.Direct port to a GX or GlobalLink 520 device for system monitoring... The Victron Energy voltage inverter is an efficient and reliable voltage inverter built on a proven and field-tested platform. The inverter incorporates a rugged toroidal transformer that has proven its reliability in Victron Energy inverters for many years. Key Features: - High starting power: Required to start loads such as inverters for LED bulbs, halogen lamps or power tools. - ECO mode: In ECO mode, the inverter switches to standby mode when the load falls below a preset value (min. load: 15 W). Once in standby mode, the inverter will switch on for a short period of time (adjustable, default: every 2.5 seconds). If the load exceeds the preset level, the inverter will remain on. - PWM solar charger: The solar charger provides battery charging with energy obtained from your solar panels. The charging algorithm is programmable. - Remote on/off: The Phoenix Inverter Control VE.Direct Remote panel (not included) can be used to turn the inverter on or off remotely. Alternatively, the remote switch can be plugged into the two-pole connector or between the battery plus and the left contact of the two-pole connector. - LED diagnostics: Refer to the manual for a description of each condition. - Bluetooth: Inverter and solar charger parameters can be read, monitored and configured via Bluetooth victronConnect app. - VE.Direct communication port: The VE.Direct port can be used to connect to a GX device, GlobalLink 520 for monitoring through the VRM portal or to connect to a computer for monitoring or configuration using the VictronConnect app. Monitoring via the VictronConnect app or GX device: - Inverter input and output voltages and % load - Solar energy, voltage and current - Operating status and alarms Fully configurable via the VictronConnect app: - Low battery voltage alarm triggering and level reset - Low battery shutdown and restart levels - Dynamic shutdown: load-dependent shutdown levels - Output voltage 210 - 245 V and frequency 50 Hz or 60 Hz - ECO mode on/off and ECO mode sensing level - Battery charging current, algorithm and voltage - Temperature compensation for battery charging or low temperature level reduction Load transfer to another AC power source: automatic transfer switch: For our low power inverters, we recommend our Filax automatic transfer switch. Filax features a very short switching time (less than 20 milliseconds), so computers and other electronic devices yes continue to operate without interruption. DC and PV connections with screw terminals: No special cable terminals or tools are required for installation Available with IEC-320 socket: IEC-320 plug included. Specifications: - 230 V AC +/- 3% 50 Hz or 60 Hz +/- 0.1% - continuous power at 25 oC: 250 VA / 200 W - peak power: 400 W - max. efficiency: 87% - self-consumption at zero load: max 4.2 W - self-consumption in ECO mode: max 0.8 W - 230 V AC connection: IEC-320 plug - operating temperature range: -40 to +60 oC (fan-assisted cooling) - humidity (non-condensing): max. 95% - protection class: IP21 - weight: 2.4 kg - dimension: 86 x 165 x 260 mm Maximum PV panel voltage: 25V Maximum PV panel current: 15A Maximum total power of PV panels: 375 Wp