T-piece 76,1 x 22 x 76,1

Product detailed description

Reduced T-pieces are essential in pressurised systems where branch connections are required. This model is commonly used in central heating, fire suppression, refrigeration, and industrial air systems. Installers working in commercial and industrial buildings often use these fittings to connect pipes in closed-loop systems where high pressure and temperature resistance are required. The fitting is suitable for both new installations and system modifications, ensuring a secure and leak-free connection without the need for welding or threading.

When integrating into a system, the fitting is pressed into place using compatible Type M jaws. It is important to ensure that the system is designed for press-fit connections and that the installation follows the manufacturer’s guidelines to avoid misalignment or improper sealing. The fitting is not certified for potable water applications and should be used only in non-drinking water systems.

Technical parameters

Material	carbon galvanized steel
Operating temperature	-20 °C
Nominal pressure	PN 16
Resistance to high pressures up to	16 bar
Weight	0.986 kg
Code	IVC41.762276
Brand	IVAR

The operating temperature range from -20 °C to +120 °C allows for use in both cold and hot environments, while the PN 16 rating ensures compatibility with systems operating up to 16 bar. These parameters are critical for sizing the component correctly and ensuring it meets the system's hydraulic and thermal demands.Installation and connection To install the T-piece, the installer must first prepare the pipe ends by cleaning and inspecting for burrs or deformations. The fitting is then pressed onto the pipe using a press tool compatible with Type M jaws. The molding indicator should be fully engaged to confirm a secure connection. Common installation errors include using incorrect jaw types, improper alignment, or failing to check the molding indicator. It is essential to verify the fit before proceeding to the next section of the system.Compatibility and accessories This T-piece is compatible with other IVAR press-fit components and systems using carbon steel piping. When ordering, ensure that the press tools and jaws are suitable for Type M connections. No additional surface coatings or limiting agents are required, and the fitting can be used in conjunction with EPDM O-rings for sealing. No specific accessories are required beyond standard installation tools.Technical background for designers The fitting operates on the principle of mechanical compression, where the press tool deforms the fitting around the pipe to create a tight seal. The carbon galvanized steel construction provides resistance to corrosion and mechanical damage, while the EPDM O-ring ensures a watertight connection. The material properties allow for integration into a wide range of systems, including those with fluctuating temperatures and pressures. The service life is influenced by the system's operating conditions, particularly the frequency of pressure and temperature changes.Service and operation Regular visual inspections are recommended to check for signs of wear, deformation, or leaks. The molding indicator should be verified during initial installation and rechecked during routine maintenance. No scheduled service intervals are specified, but any anomalies should be addressed immediately to prevent system failure.Frequently asked questions

Can this T-piece be used in solar heating systems?
Yes, the fitting is suitable for solar heating applications as it supports operating temperatures up to +120 °C and is compatible with press-fit connections.

Is it compatible with inert gas systems?
Yes, the fitting can be used with inert gases as long as the system operates within the specified pressure and temperature limits.

Can it be used with copper pipes?
No, the fitting is designed for use with carbon steel pipes and is not compatible with copper or other non-steel materials.

Is it suitable for fire suppression systems?
Yes, the fitting is suitable for fire suppression systems as it supports high pressures and is compatible with press-fit installation methods.