IVAR.IVC91 branch piece, one-sided, carbon steel press fitting – 18–15 mm IVAR.IVC91
Code: IVC91.1815Related products
Product detailed description
The IVAR.IVC91 one-sided branch piece in size 18–15 mm is part of the IVAR carbon steel press system. Its through section carries press sockets for 18 mm pipe at both ends, while a 15 mm branch leads off in one direction (PRESS × d × PRESS layout). One fitting thus handles both the branch and the pipe crossover.
Key features
- carbon steel galvanized inside and outside, EPDM sealing O-ring
- maximum operating pressure PN 16
- operating temperature −20 °C to +85 °C, short-term up to +120 °C
- pressed with M-profile jaws
- red stripe indicates whether the joint has been pressed
- patented LBP (Leak Before Press) O-ring – an unpressed joint leaks during the pressure test
- dimensions A and B: 40 mm
Where to use it
Closed heating systems, permanently water-filled sprinkler and fire protection installations, compressed dry air, inert gases and industrial pipework. The fitting is not suitable for drinking water, nor for cooling lines without surface protection.
Installation note: always follow the installation instructions issued by the system manufacturer and flush the entire system before commissioning. IVAR recommends treating the heating water with GEL.LONG LIFE 100.
The IVAR.IVC91 range covers sizes 15–15 to 28–15 mm. For branches in two directions, choose the straight-through IVAR.IVC90.
Technical data
| Code | IVC91.1815 |
| Manufacturer | IVAR |
| Type | IVAR.IVC91 |
| Design | one-sided – branch in one direction |
| Size | 18–15 mm |
| Dimensions A / B | 40 / 40 mm |
| Max. operating pressure | PN 16 |
| Operating temperature | −20 to +85 °C, short-term max. +120 °C |
| Material | carbon steel, galvanized inside and outside |
| Seal | EPDM O-ring, LBP design |
| Press jaws | M profile |
Frequently asked questions
Which systems is this branch piece designed for?
It is intended for closed heating systems, permanently water-filled sprinkler installations, compressed dry air, inert gases and industrial pipework. It must not be used for drinking water, nor for cooling lines without surface protection.
How can I check that the joint has been pressed?
A red stripe on the fitting indicates whether it has been pressed. In addition, the LBP (Leak Before Press) O-ring lets water escape during the pressure test if a joint was left unpressed.
What should be done before the system is put into operation?
Flush the whole system according to the manufacturer's instructions. IVAR recommends treating the heating water with GEL.LONG LIFE 100, and the installation manual of the system manufacturer must always be followed.
Additional parameters
| Category: | IVAR.IVC45 - 90° crossovers |
|---|---|
| Warranty: | 2 years |
| Weight: | 0.048 kg |
| Material: | galvanized carbon steel |
| Nominal pressure: | PN 16 |
| Operating temperature: | -20 °C |
| Code: | IVC91.1815 |
| Manufacturer: | IVAR |
| Type: | IVAR.IVC91 |
| Design: | one-sided – branch in one direction |
| Size: | 18–15 mm |
| Dimensions A / B: | 40 / 40 mm |
| Max. operating pressure: | PN 16 |
| Operating temperature: | −20 to +85 °C, short-term max. +120 °C |
| Material: | carbon steel, galvanized inside and outside |
| Seal: | EPDM O-ring, LBP design |
| Press jaws: | M profile |
Discussion
Be the first who will post an article to this item!