IVAR.IVC90 branch piece, straight-through, carbon steel press fitting – 22–15 mm IVAR.IVC90
Code: IVC90.2215Related products
Product detailed description
The IVAR.IVC90 straight-through branch piece in size 22–15 mm is part of the IVAR carbon steel press system. Its through section carries press sockets for 22 mm pipe at both ends, while 15 mm branches lead off in two directions (PRESS × d × PRESS layout). One fitting thus handles both the branch and the pipe crossover.
Key features
- carbon steel galvanized inside and outside, EPDM sealing O-ring
- maximum operating pressure PN 16
- operating temperature −20 °C to +85 °C, short-term up to +120 °C
- pressed with M-profile jaws
- red stripe indicates whether the joint has been pressed
- patented LBP (Leak Before Press) O-ring – an unpressed joint leaks during the pressure test
- dimensions A and B: 40 mm
Where to use it
Closed heating systems, permanently water-filled sprinkler and fire protection installations, compressed dry air, inert gases and industrial pipework. The fitting is not suitable for drinking water, nor for cooling lines without surface protection.
Installation note: always follow the installation instructions issued by the system manufacturer and flush the entire system before commissioning. IVAR recommends treating the heating water with GEL.LONG LIFE 100.
The IVAR.IVC90 range covers sizes 15–15 to 35–15 mm. For a branch to one side only, choose the one-sided IVAR.IVC91.
Technical data
| Code | IVC90.2215 |
| Manufacturer | IVAR |
| Type | IVAR.IVC90 |
| Design | straight-through – branches in two directions |
| Size | 22–15 mm |
| Dimensions A / B | 40 / 40 mm |
| Max. operating pressure | PN 16 |
| Operating temperature | −20 to +85 °C, short-term max. +120 °C |
| Material | carbon steel, galvanized inside and outside |
| Seal | EPDM O-ring, LBP design |
| Press jaws | M profile |
Frequently asked questions
Which systems is this branch piece designed for?
It is intended for closed heating systems, permanently water-filled sprinkler installations, compressed dry air, inert gases and industrial pipework. It must not be used for drinking water, nor for cooling lines without surface protection.
How can I check that the joint has been pressed?
A red stripe on the fitting indicates whether it has been pressed. In addition, the LBP (Leak Before Press) O-ring lets water escape during the pressure test if a joint was left unpressed.
What should be done before the system is put into operation?
Flush the whole system according to the manufacturer's instructions. IVAR recommends treating the heating water with GEL.LONG LIFE 100, and the installation manual of the system manufacturer must always be followed.
Additional parameters
| Category: | IVAR.IVC45 - 90° crossovers |
|---|---|
| Warranty: | 2 years |
| Weight: | 0.048 kg |
| Material: | galvanized carbon steel |
| Nominal pressure: | PN 16 |
| Operating temperature: | -20 °C |
| Code: | IVC90.2215 |
| Manufacturer: | IVAR |
| Type: | IVAR.IVC90 |
| Design: | straight-through – branches in two directions |
| Size: | 22–15 mm |
| Dimensions A / B: | 40 / 40 mm |
| Max. operating pressure: | PN 16 |
| Operating temperature: | −20 to +85 °C, short-term max. +120 °C |
| Material: | carbon steel, galvanized inside and outside |
| Seal: | EPDM O-ring, LBP design |
| Press jaws: | M profile |
Discussion
Be the first who will post an article to this item!